MDMA Purity Test Kit – EZTest
MDMA purity is very difficult to measure, however with this test kit this can be measured.
The MDMA Purity kit tests for the purity of a sample (stronger samples of MDMA will give a darker reaction)
These are the reactions you should get when you place MDMA in the test kit
Unlike the presumptive versions of this test, the MDMA purity test kit takes approximately 45 minutes to fully develop.
All EZ tests use a chemical reagent absorbed in silica gel (reason why there may be crystals on the side), which is held inside a glass ampoule.
When a sample is added to these chemicals inside the ampoule if a reaction occurs a colour change will take place. This colour should be compared to the colour chart included on the instructions within the package, to give an indication as what could be in the sample
EZ Test Kits Simple Use steps below:
Step 1 – Prepare some of the substance for analysis. Only a small amount is required (20mg approximately depending on the test).
Step 2 – lightly tap the unopened ampoule several times against a hard surface to make any particles sticking to the side of the ampoule fall downwards and shake to mix contents.
Step 3 – Hold the ampoule in one hand and snap off the top part at the fracture line.
Step 4 – Keep the ampoule in the upright position and transfer your sample into the ampoule. After this carefully place the cap on the opened ampoule making sure it is sealed. – LSD test kit and Cannabis tests have a small granule in the cap which is a catalyst and also needs to be added. – One easy method for adding your substance is simply fold a piece of paper and ‘funnel’ the substance into the test tube making sure it does not blow around in wind.
Step 5 – Allow a short time (30 seconds or so) for the sample and the reagents / granule to mix.
Step 6 – Compare the colour change (if any) with the colours on the colour chart included in the packaging. Any colour change should fully develop within 1 – 2 minutes (note that some tests such as the MDMA purity test kit can take up to 45 minutes to develop).
Step 7- When finished, place the used ampoule in a sealed bag and dispose of responsibly in a non-recycle bin.
Bongs Online does not condone the use of any illicit or controlled substances.
The information relating to drug test kits on this website is presented by Bongs Online Australia for the purpose of disseminating information to inform site visitors.
Check Out Our Other Testing Kits Available Here!
